INSTALLATION
Removal / installation
| 1. INSTALL TRANSMISSION WIRE |
Coat a new O-ring with ATF and install it to the transmission wire.
Install the transmission wire with the bolt.
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
Connect the transmission wire connector.
| 2. CONNECT TRANSMISSION WIRE |
Connect the 9 connectors to the solenoid valves.
Install the ATF temperature sensor with the bolt.
- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
Install the 2 clamps with the 2 bolts.
- Torque:
- Bolt A:
- 6.4 N*m{ 65 kgf*cm , 57 in.*lbf }
- Bolt B:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
| 3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
Coat a new O-ring with ATF.
Install the O-ring.
Install the oil strainer with the 4 bolts.
- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
| 4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY |
Install the 3 magnets in the oil pan.
Install a new gasket and the oil pan to the transmission case with the 20 bolts.
- Torque:
- 4.4 N*m{ 45 kgf*cm , 39 in.*lbf }
| 5. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY |
Install the No. 1 exhaust pipe support bracket sub-assembly to the automatic transmission assembly with the 2 bolts.
- Torque:
- 43 N*m{ 438 kgf*cm , 32 ft.*lbf }
| 6. ADD AUTOMATIC TRANSMISSION FLUID |
| 7. INSTALL NO. 2 ENGINE UNDER COVER |
| 8. RESET MEMORY |