INSPECTION

Inspection

INSPECT PATTERN SELECT SWITCH

1. Measure the resistance according to the value(s) in the table below.
   

   Standard resistance 

   Switch Condition	Tester Connection	Specified Condition
   Pattern select switch (PWR)	3 - 7	Below 1 Ω
   Pattern select switch (NORM)	3 - 7	10 kΩ or higher
   Press continuously Pattern select switch (SNOW)	1 - 3	Below 1 Ω
   Release Pattern select switch (SNOW)	1 - 3	10 kΩ or higher

   If the resistance value is not as specified, replace the pattern select switch.