DATA LIST / ACTIVE TEST
System information
| READ DATA LIST |
- HINT:
- Using the intelligent tester's DATA LIST allows switch, sensor, actuator, and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Read the DATA LIST according to the display on the tester.
ECM (Cruise control): Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Vehicle Spd
Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
Actual vehicle speed
-
Memory Spd
Cruise control memorized speed / min.: 36 km/h (22.5 mph), max.: 200 km/h (125 mph)
Actual stored vehicle speed
-
Rqst Torqur
Cruise request torque / min.: -1,024 Nm, max.: 1,016 Nm
-
-
Cruise Control
Cruise control system active condition / ON or OFF
ON: Cruise control activated
OFF: Cruise control deactivated
-
Main SW (Main)
Main switch signal (Main CPU) / ON or OFF
ON: Main switch on (Pushed on)
OFF: Main switch off (Pushed off)
"3"
CCS Indicator M
Cruise indicator signal (Main CPU) / ON or OFF
ON: "CRUISE" on
OFF: "CRUISE" off
"2"
Cancel SW
CANCEL switch signal / ON or OFF
ON: CANCEL switch on
OFF: CANCEL switch off
-
SET/COAST SW
SET / COAST switch signal / ON or OFF
ON: SET / COAST switch on
OFF: SET / COAST switch off
-
RES/ACC SW
RES / ACC switch signal / ON or OFF
ON: RES / ACC switch on
OFF: RES / ACC switch off
-
STP Light SW M
Stop light switch signal (Main CPU) / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Shift D Pos
PNP switch signal (D position) / ON or OFF
ON: Shift lever in D
OFF: Shift lever not in D
-
Clutch switch signal / ON or OFF
ON: Clutch pedal released
OFF: Clutch pedal depressed
-
- HINT:
- "3" is OK but "1" is NG → ECM failure
- "1" is OK but "2" is NG → DTC output or ECM failure
- "3" is OK but CRUISE main indicator light does not illuminate → CRUISE main indicator light, wire harness, or ECM failure
- "3" is OK but "1" is NG → ECM failure
| PERFORM ACTIVE TEST |
- HINT:
- Performing the intelligent tester's ACTIVE TEST allows relays, VSVs, actuators, and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Perform the ACTIVE TEST according to the display on the tester.
- HINT:
- The engine switch must be turned on (IG) to proceed ACTIVE TEST using the intelligent tester.
Combination meter: Item
Vehicle Condition / Test Details
Diagnostic Note
CRUISE INDIC
Turns CRUISE main indicator light ON / OFF
-