INSPECTION

Inspection

INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

1. Measure the resistance between the terminals.
   

   Standard resistance:

   6.9 to 7.9 Ω at 20°C (68°F)
   

   If the result is not as specified, replace the oil control valve.
   

2. Connect the battery's positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the valve.
   

   OK:

   Condition	Specified Condition
   Battery positive (+) voltage is applied	Valve moves in left arrow direction shown in illustration
   Battery positive (+) voltage is cut off	Valve moves in right arrow direction shown in illustration

   If the result is not as specified, replace the oil control valve.
   

   NOTICE:

   If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be output.