REASSEMBLY
Removal / installation
| 1. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
| 2. INSTALL REAR DISC |
Aligning the matchmarks, install the rear disc.
- HINT:
- When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.
| 3. ADJUST PARKING BRAKE SHOE CLEARANCE |
- HINT:
- (Click here)
| 4. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG |
| 5. INSTALL PISTON SEAL |
Apply lithium soap base glycol grease to a new piston seal.
Install the piston seal to the rear cylinder assembly.
| 6. INSTALL CYLINDER BOOT |
Apply lithium soap base glycol grease to the piston and a new cylinder boot.
Install the cylinder boot to the piston as shown in the illustration.
| 7. INSTALL REAR DISC BRAKE PISTON |
Install the cylinder boot to the rear cylinder assembly.
- NOTICE:
- Install the boot securely to the grooves of the cylinder.
Push in the piston by hand and install the boot seal onto the grooves of the piston.
- NOTICE:
- Install the boot sent securely onto the grooves of the piston.
| 8. INSTALL REAR DISC BRAKE CYLINDER SLIDE BUSHING |
Apply lithium soap base glycol grease to a new cylinder slide bushing.
Install the cylinder slide bushing to the rear cylinder assembly.
- NOTICE:
- Install the cylinder slide bushing securely to the grooves of the rear cylinder assembly.
| 9. INSTALL REAR BRAKE BUSHING DUST BOOT |
Apply lithium soap base glycol grease to a new bushing dust boot.
Install the bushing dust boot to the rear cylinder assembly.
- NOTICE:
- Install the bushing dust boot securely to the grooves of the rear cylinder assembly.
| 10. INSTALL CALIPER SUPPORT BRACKET |
Apply lithium soap base glycol grease to the caliper support bracket.
Install the caliper support bracket to the rear cylinder assembly.
- NOTICE:
- Install the bushing dust boot securely to the grooves of the caliper support bracket.