REMOVAL

Removal / installation

1. REMOVE COOL AIR INTAKE DUCT SEAL

1. Remove the 11 clips and intake duct seal.
   

2. REMOVE NO. 1 INLET AIR CLEANER

1. Remove the bolt, clip and inlet air cleaner.
   

3. REMOVE V-BANK COVER SUB-ASSEMBLY

1. Raise the V-bank cover to disengage the clip on the rear of the cover. Raise the cover again to disengage the 2 clips on the front of the cover and remove the cover.
   

   NOTICE:

   Attempting to disengage both front and rear clips at the same time may cause the cover to break.

4. REMOVE V-RIBBED BELT

1. While releasing the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.
   

2. While turning the belt tensioner counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the belt tensioner.