DATA LIST / ACTIVE TEST
System information
| READ DATA LIST |
- HINT:
- Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Read the Data List according to the display on the tester.
SLIDE ROOF: Item
Measurement Item/Display (Range)
Normal Condition
Diagnostic Note
HALL IC1 PULSE
Sliding roof operation signal/LO or HI
LO: Sliding roof motor is not operating
HI: Sliding roof motor is operating
-
HALL IC1 STATUS
Sliding roof operation signal/NORMAL or LOCK
NORMAL: Sliding roof motor is operating
LOCK: Sliding roof motor is not operating
-
HALL IC2 PULSE
Sliding roof operation signal/LO or HI
LO: Sliding roof motor is not operating
HI: Sliding roof motor is operating
-
HALL IC2 STATUS
Sliding roof operation signal/NORMAL or LOCK
NORMAL: Sliding roof motor is operating
LOCK: Sliding roof motor is not operating
-
IG (DIRCT SIG)
Ignition switch signal/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
IG (MPX)
Ignition switch signal (MPX signal)/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
D-DOOR WARN SW
Driver's door courtesy light switch signal/ON or OFF
ON: Driver's door is open
OFF: Driver's door is closed
-
KEY OPEN OPERT
Key-linked sliding roof open signal/ON or OFF
ON: Door lock is turned to open position using key
OFF: Door lock is not turned
-
KEY CLOSE OPERT
Key-linked sliding roof close signal/ON or OFF
ON: Door lock is turned to close position using key
OFF: Door lock is not turned
-
WIRLES OPN OPRT
Wireless sliding roof open signal/ON or OFF
ON: Transmitter UNLOCK switch is pressed
OFF: Transmitter UNLOCK switch is not pressed
-
WIRLES CL OPRT
Wireless sliding roof close signal/ON or OFF
ON: Transmitter UNLOCK switch is not pressed
OFF: Transmitter UNLOCK switch is pressed
-
OPEN/DOOR KEY
Key-linked sliding roof open permit signal/Available or Not available
Available: Driver side door is not closed within 45 sec. after engine switch is turned off.
Not Available: Any status except "AVAIL" status.
-
CLOSE/DOOR KEY
Key-linked sliding roof close permit signal/Available or Not available
Available: Driver side door is not closed within 45 sec. after engine switch is turned off.
Not Available: Any status except "AVAIL" status.
-
OPEN/WIRELESS
Wireless sliding roof open permit signal/Available or Not available
Available: No key is in vehicle and all doors are closed.
Not Available: Any status except "AVAIL" status.
-
CLOSE/WIRELESS
Wireless sliding roof close permit signal/Available or Not available
Available: No key is in vehicle and all doors are opened.
Not Available: Any status except "AVAIL" status.
-
DOOR KEY OPER
Key-linked sliding roof operating direction signal/Tilt or Slide
TILT: Slide close direction → Tilt up direction
SLIDE: Slide open direction → Tilt down direction
-
WIRELESS OPER
Wireless sliding roof operating direction signal/Tilt or Slide
TILT: Slide close direction → Tilt up direction
SLIDE: Slide open direction → Tilt down direction
-
KEY OFF PERMS
Key-OFF sliding roof operation permit signal/ON or OFF
ON: Driver side door is not closed within 45 sec. after engine switch is turned off.
OFF: Any status except "ON" status
-
| PERFORM ACTIVE TEST |
- HINT:
- Performing the intelligent tester's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Perform the Active Test according to the display on the tester.
SLIDE ROOF: Item
Test Details
Diagnostic Note
SLIDE ROOF
Operate sliding roof CLOSE/UP
-
SLIDE ROOF
Operate sliding roof OPEN/DOWN
-