INSPECTION

Inspection

INSPECT FRONT POWER SEAT LUMBAR SWITCH LH

1. Measure the resistance between the terminals when the switch is operated
   

   Standard resistance:

   Tester Connection	Switch Condition	Specified Condition
   4 (E) - 3 (R)	HOLD	Below 1 Ω
   2 (B) - 5 (H)	HOLD	Below 1 Ω
   4 (E) - 3 (R)	OFF	Below 1 Ω
   5 (H) - 1 (E)	OFF	Below 1 Ω
   2 (B) - 3 (R)	RELEASE	Below 1 Ω
   5 (H) - 1 (E)	RELEASE	Below 1 Ω

   If the result is not as specified, replace the switch.
   

INSPECT FRONT POWER SEAT LUMBAR SWITCH RH

1. Measure the resistance between the terminals when the switch is operated.
   

   Standard resistance:

   Tester Connection	Switch Condition	Specified Condition
   1 (GND) - 5 (R)	HOLD	Below 1 Ω
   2 (B) - 3 (H)	HOLD	Below 1 Ω
   1 (GND) - 5 (R)	OFF	Below 1 Ω
   3 (H) - 4 (E)	OFF	Below 1 Ω
   3 (B) - 5 (R)	RELEASE	Below 1 Ω
   3 (H) - 4 (E)	RELEASE	Below 1 Ω

   If the result is not as specified, replace switch.