TERMINALS OF ECU
System information
| CHECK REAR SUNSHADE RELAY |
Disconnect the Q24 relay connector.
Measure the voltage and resistance of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side connector.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
IG (Q24-1) - E (Q24-5)
Y - W-B
Power source (IG)
Engine switch off
Below 1 V
IG (Q24-1) - E (Q24-5)
Y - W-B
Power source (IG)
Engine switch on (IG)
10 to 14 V
SW (Q24-3) - E (Q24-5)
L - W-B
Rear sunshade switch signal
Engine switch on (IG)
Rear sunshade switch OFF
10 kΩ or higher
SW (Q24-3) - E (Q24-5)
L - W-B
Rear sunshade switch signal
Engine switch on (IG)
Rear sunshade switch ON
Below 1 Ω
E (Q24-5) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
Connect the Q24 relay connector.
Measure the voltage of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side connector.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
REV (Q24-2) - Body ground
R - Body ground
Reverse signal
Engine switch on (IG), shift lever on except R
Below 1 V
REV (Q24-2) - Body ground
R - Body ground
Reverse signal
Engine switch on (IG), shift lever on R
10 to 14 V
SW (Q24-3) - Body ground
L - Body ground
Rear sunshade switch signal
Engine switch on (IG), rear sunshade switch not pushed
10 to 14 V
SW (Q24-3) - Body ground
L - Body ground
Rear sunshade switch signal
Engine switch on (IG), rear sunshade switch pushed
Below 1.5 V