Lexus IS250 · Service Manual BODY

REPAIR

Removal / installation


1. IF NECESSARY, REPAIR THE DEFOGGER WIRE

B106758E03

  1. Clean the broken wire tips with a grease, wax and silicone remover.

  1. Place the masking tape along both sides of the wire.

  1. B106759
    Thoroughly mix the repair agent (Dupont paste No. 4817 or equivalent).

  1. Using a fine tip brush, apply a small amount of the agent to the wire.

  1. After a few minutes, remove the masking tape.

    NOTICE:
    Do not repair the defogger wire again for at least 24 hours.

← ON-VEHICLE INSPECTIONRear Window Defogger System does not Operate →