INSPECTION
Inspection
| INSPECT TIRE |
Check the tires for wear and proper inflation pressure.
Tire Size
Specified Value kPa (kgf*cm2,psi)
More than 210 km/h (132 mph)
From 160 km/h (100 mph) to 210 km/h 132 mph)
160 km/h (100 mph) or less
Front
Rear
Front
Rear
Front
Rear
205/55R16 89W
310 (3.1, 45)
330 (3.3, 48)
290 (3.9, 42)
310 (3.1, 45
240 (2.4, 35)
260 (2.6, 38)
225/45R17 90W*1
300 (3.0, 44)
-
280 (2.8, 41)
-
240 (2.4, 35)
-
245/45R17 95W*2
-
320 (3.2, 46)
-
300 (3.0, 44)
-
260 (2.6, 38)
225/40R18 88Y*1
320 (3.2, 46)
-
300 (3.0, 44)
-
240 (2.4, 35)
-
255/40R18 95Y*2
-
340 (3.4, 49)
-
320 (3.2, 46)
-
260 (2.6, 38)
*2: Only for rear tire
Using a dial indicator, check the runout of the tires.
- Tire runout:
- 1.0 mm (0.039 in.) or less
| ROTATE TIRE |
 |
- HINT:
- Rotate the tires as shown in illustration.
- 2WD models with 17-inch tires or 18-inch tires cannot be rotated.
- Rotate the tires as shown in illustration.
| INSPECT WHEEL BALANCE |
Check and adjust the off-the-car balance.
If necessary, check and adjust the on-the-car balance.
- Imbalance after adjustment:
- 8.0 g (0.018 lb.) or less.
- HINT:
- In the case of 16-inch wheels, balance weight should be installed by tapping.
- NOTICE:
- Remove dirt, oil and water from the surface where the balance weight is to be adhered with a cleaning detergent.
- Do not touch the sticking surface of the tape.
- Adhere the sticking type balance weight to the flat position shown in the illustration.
- Push the balance weight securely with a finger to adhere it to the position.
- Do not reuse a balance weight.
- Use the LEXUS genuine tape weight.
- Remove dirt, oil and water from the surface where the balance weight is to be adhered with a cleaning detergent.
| INSPECT BEARING LOOSENESS |
| INSPECT FRONT AXLE HUB RUNOUT |
| INSPECT REAR AXLE HUB RUNOUT |