DATA LIST / ACTIVE TEST
System information
| DATA LIST |
- HINT:
- By accessing the DATA LIST displayed on the intelligent tester, you can perform such functions as reading the values of switches and sensors without removing any parts. Reading the DATA LIST is the first step in troubleshooting and is one method to shorten labor time.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Operate the intelligent tester according to the steps on the display and select DATA LIST.
Entry & Start: Item
Measurement Item / Range (Display)
Normal Condition
Diagnostic Note
Steering Lock Sleep Cond
Steering lock ECU condition / YES or NO
YES: Sleep is permitted
NO: Sleep is prohibited
-
Steering Lock Start Cond
Steering lock start condition / YES or NO
YES: Wake-up signal has been sent
NO: Wake-up signal has not been sent
-
Engine Start Condition
Engine start condition / OK or NG
YES: Engine start is permitted
NO: Engine start is prohibited
-
Sensor Value
Sensor malfunction / NG (PAST) or OK
NG (PAST): Sensor malfunction
OK: No malfunction
-
Power Supply Short
Short in ECU / NG (PAST) or OK
NG (PAST): Short in ECU
OK: No malfunction
-
Power Supply Open
Open in ECU / NG (PAST) or OK
NG (PAST): Open in ECU
OK: No malfunction
-
Motor Driver Short
Short in driver ECU / NG (PAST) or OK
NG (PAST): Short in driver ECU
OK: No malfunction
-
Motor Driver Open
Open in driver ECU / NG (PAST) or OK
NG (PAST): Open in driver ECU
OK: No malfunction
-
Lock/Unlock Receive
Steering lock command reception record / YES or NO
YES: Steering lock / unlock signal received
NO: Steering lock / unlock signal no received
-
Lock Bar Struck Error
Lock bar stuck malfunction / NG (PAST) or OK
NG (PAST): Lock bar stuck malfunction
OK: No malfunction
-
Push Start Error
Push button start function malfunction / NG (PAST) or OK
NG (PAST): Malfunction in push button start
OK: No malfunction
-
IG2 Status
IG2 voltage / OK or OFF
ON: 10 to 14 V
OFF: Below 1 V
-
IG (Lin)
LIN bus start-up status / ON or OFF
ON: LIN bus started-up
OFF: LIN bus not started-up
-
Steering Lock
Steering lock sensor on status / Set or Unset
Set: Steering lock sensor is on
Unset: Steering lock sensor is off
-
Steering Unlock
Steering unlock sensor on status / Set or Unset
Set: Steering unlock sensor is on
Unset: Steering unlock sensor is off
-
| ACTIVE TEST |
- HINT:
- Performing the ACTIVE TEST is one of the methods to shorten labor time. It is possible to display the DATA LIST during the ACTIVE TEST.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Following the display on the intelligent tester, perform the ACTIVE TEST.
BODY: Item
Test Details
Diagnostic Note
Security Indicator
Security Indicator / ON or OFF
-