Tilt and Telescopic Manual Switch Circuit

DESCRIPTION

The signals generated by operating the manual switch are sent to the multiplex tilt & telescopic ECU through the communication bus.

INSPECTION PROCEDURE

1. READ VALUE OF INTELLIGENT TESTER (COMBINATION SWITCH)

1. Connect the intelligent tester to the DLC3.

2. Turn the engine switch on (IG) and turn the intelligent tester on.

3. Select "COMBINATION SWITCH".

4. Select the following items from the DATA LIST.

5. Check the tilt and telescopic manual switch.

   COMBINATION SWITCH: 

   Item	Measurement Item / Range (Display)	Normal Condition	Normal Condition
   Telesc Short SW	Telescopic SHORT switch status / OFF or ON	OFF: Telescopic short is not activated by manual switch ON: Telescopic short is activated by manual switch	-
   Telesc Long SW	Telescopic LONG switch status / OFF or ON	OFF: Telescopic long is not activated by manual switch ON: Telescopic long is activated by manual switch	-
   Tilt Down SW	Tilt DOWN switch status / OFF or ON	OFF: Tilt down is not activated by manual switch ON: Tilt down is activated by manual switch	-
   Tilt Up SW	Tilt UP switch status / OFF or ON	OFF: Tilt up is not activated by manual switch ON: Tilt up is activated by manual switch	-

   OK:

   "ON" is displayed on the tester screen when each switch is turned on.
   

   "OFF" is displayed on the tester screen when each switch is turned off.
   

NG	REPLACE TILT & TELESCOPIC SWITCH

OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE