Lexus IS250 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B125513E01
    Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedures for the RH side and LH side.

  1. B125605E01
    Put protective tape around the front bumper assembly.

  1. Using a clip remover, remove the 2 clips

  1. Remove the 2 radiator grille protectors.

  1. Remove the bolt and 10 screws.

  1. B125515
    Disengage the 5 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedures for the RH side and LH side.

  1. Disconnect the headlight washer hose. (w/ headlight cleaner system)

  1. Disconnect the connector and remove the front bumper assembly.


2. REMOVE HIGH PITCHED HORN

  1. E114155E01
    Disconnect the connector.

  1. Remove the bolt and high pitched horn.

← COMPONENTSINSPECTION →