Lexus IS250 · Service Manual CRUISE CONTROL SYSTEM

REMOVAL

Removal / installation


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation (Click here).


2. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B125512
    Using a clip remover, remove the 11 clips and cool air intake duct seal.


3. REMOVE FRONT BUMPER ASSEMBLY

  1. B125513E01
    Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedures for the RH side and LH side.

  1. B125605E01
    Put protective tape around the front bumper assembly.

  1. Using a clip remover, remove the 2 clips

  1. Remove the 2 radiator grille protectors.

  1. Remove the bolt and 10 screws.

  1. B125515
    Disengage the 5 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedures for the RH side and LH side.

  1. Disconnect the headlight washer hose. (w/ headlight cleaner system)

  1. Disconnect the connector and remove the front bumper assembly.


4. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

  1. Disconnect the connector.

  1. E123140
    Remove the 3 bolts and the millimeter wave radar sensor assembly.

← COMPONENTSADJUSTMENT →