Lexus IS250 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. A127530
    Remove the 11 clips and intake duct seal.


2. REMOVE FRONT BUMPER ASSEMBLY

  1. B125513E01
    Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedures for the RH side and LH side.

  1. B125605E01
    Put protective tape around the front bumper assembly.

  1. Using a clip remover, remove the 2 clips

  1. Remove the 2 radiator grille protectors.

  1. Remove the bolt and 10 screws.

  1. B125515
    Disengage the 5 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedures for the RH side and LH side.

  1. Disconnect the headlight washer hose. (w/ headlight cleaner system)

  1. Disconnect the connector and remove the front bumper assembly.


3. REMOVE HEADLIGHT CLEANER WASHER NOZZLE

  1. E119628
    Extend the headlight cleaner washer nozzle.

  1. Remove the headlight cleaner washer nozzle.

    HINT:
    Use the same procedures for the RH side and the LH side.


4. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY

  1. E119627
    Disconnect the headlight washer hose.

  1. Remove the bolt.

  1. Disengage the 2 claws and remove the headlight washer actuator sub-assembly as shown in the illustration.

    HINT:
    Use the same procedures for the RH side and the LH side.

← COMPONENTSINSPECTION →