REMOVAL
Removal / installation
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait for 90 seconds after disconnecting the cable to prevent airbag deployment. (Click here)
| 2. REMOVE LAP BELT OUTER ANCHOR COVER |
Disengage the 3 claws and remove the lap belt outer anchor cover.
| 3. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY |
Remove the bolt and disconnect the floor end of the front seat outer belt assembly.
| 4. REMOVE FRONT DOOR SCUFF PLATE (w/o Illumination) |
Put protective tape around the front door scuff plate.
Using a moulding remover, disengage the 4 clips.
Disengage the 7 claws and remove the front door scuff plate LH.
| 5. REMOVE FRONT DOOR SCUFF PLATE (w/ Illumination) |
Put protective tape around the front door scuff plate.
Using a moulding remover, disengage the 4 clips.
Disengage the 7 claws and remove the front door scuff plate LH.
Disconnect the connector.
| 6. REMOVE REAR DOOR SCUFF PLATE |
Put protective tape around the rear door scuff plate.
Using a moulding remover, disengage the 2 clips.
Disengage the 5 claws and remove the the rear door scuff plate LH.
| 7. REMOVE LOWER CENTER PILLAR GARNISH |
Disengage the 3 claws and 5 clips, and remove the lower center pillar garnish LH.
| 8. REMOVE CENTER PILLAR GARNISH |
Remove the 2 screws.
Disengage the 2 claws and remove the center pillar garnish LH by pulling it down.
| 9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY |
Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.
- HINT:
- Tape the screwdriver tip before use.
Disconnect the connectors.
Remove the 2 bolts and the front seat outer belt assembly.