Lexus IS250 · Service Manual BRAKE

REMOVAL

Removal / installation


1. PRECAUTION

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the terminal to prevent airbag deployment.


3. REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)
For w/o Illumination (Click here)
For w/ Illumination (Click here)

4. REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)
For w/o Illumination (Click here)
For w/ Illumination (Click here)

5. REMOVE FRONT DOOR OPENING TRIM COVER LH (for LHD)

  1. B123347
    Disengage the 6 claws and remove the front door opening trim cover LH.


6. REMOVE FRONT DOOR OPENING TRIM COVER RH (for RHD)

  1. B123353
    Disengage the 6 claws and remove the front door opening trim cover RH.


7. REMOVE INSTRUMENT SIDE PANEL LH (for LHD)

  1. B123348
    Using a moulding remover, disengage the 5 claws and 3 clips, and then remove the side instrument panel LH.


8. REMOVE INSTRUMENT SIDE PANEL RH (for RHD)

  1. B123354
    Using a moulding remover, disengage the 5 claws and 3 clips, and then remove the side instrument panel RH.


9. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

  1. B123349E01
    Remove the 2 screws <E>.

  1. Push the 2 claws in the direction indicated by the arrow to disengage them.

  1. Remove the No. 1 instrument panel under cover sub-assembly from the guide as shown in the illustration and pull the cover toward the rear of the vehicle.

  1. Disconnect the connectors and remove the No. 1 instrument panel under cover sub-assembly.


10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

  1. B123350
    Disengage the 7 clips.

  1. Disconnect the connectors and remove the lower instrument panel finish panel sub-assembly.


11. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

12. REMOVE STOP LIGHT SWITCH ASSEMBLY

  1. C110240E01
    Disconnect the connectors.

  1. C110243E01
    Loosen the lock nut and remove the stop light switch assembly.

← ON-VEHICLE INSPECTIONINSPECTION →