Lexus IS250 · Service Manual BODY

REMOVAL

Removal / installation


1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

  1. B122641
    Using a screwdriver wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel plug.


2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

  1. B122642
    Using a screwdriver wrapped with protective tape, disengage the 4 claws and the 2 clips.

  1. Disconnect the connector and remove the power window regulator master switch assembly.


3. REMOVE COURTESY LIGHT ASSEMBLY

  1. B122643
    Disengage the claw and remove the courtesy light assembly.

  1. Disconnect the connector.


4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

  1. B122644
    Remove the 2 screws.

  1. Using the clip remover, disengage the 9 clips.

  1. B127038E01
    Pull out the front door trim board in the direction indicated by the arrow.

  1. Remove the reference bosses from the front door panel.

  1. Raise the front door trim board to disengage the 4 claws and remove the front door trim board together with the front door inner glass weatherstrip.

  1. B122646
    Disconnect the cables and each connector from the back side of the inside handle and remove the front door trim board sub-assembly.

  1. Remove the 2 front door trim board retainers (green) from the front door trim board.


5. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP

  1. B127040
    Disengage the 4 clips as shown in the illustration and remove the front door inner glass weatherstrip from the front door trim board.


6. REMOVE FRONT DOOR FRAME COVER

  1. B125577
    Remove the nut and front door frame cover.


7. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY

  1. B125578E01
    Fully open the front door glass.

  1. Put protective tape on the door below the front door belt moulding assembly.

  1. Using a moulding remover, disengage the 7 clips and remove the front door belt moulding assembly.

← COMPONENTSINSTALLATION →