Lexus IS250 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B125512
    Using a clip remover, remove the 11 clips and cool air intake duct seal.


2. REMOVE FRONT BUMPER ASSEMBLY

  1. B125513E01
    Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedures for the RH side and LH side.

  1. B125605E01
    Put protective tape around the front bumper assembly.

  1. Using a clip remover, remove the 2 clips

  1. Remove the 2 radiator grille protectors.

  1. Remove the bolt and 10 screws.

  1. B125515
    Disengage the 5 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedures for the RH side and LH side.

  1. Disconnect the headlight washer hose. (w/ headlight cleaner system)

  1. Disconnect the connector and remove the front bumper assembly.


3. REMOVE FOG LIGHT ASSEMBLY

  1. E120526E01
    Disengage the clamp.

  1. E120527E01
    Disengage the 3 pins and remove the bolt and fog light assembly.

← COMPONENTSDISASSEMBLY →