Lexus IS250 · Service Manual BODY ELECTRICAL

DISASSEMBLY

Removal / installation


1. REMOVE REAR COMBINATION LIGHT BODY GASKET

  1. E120535
    Remove the rear combination light body gasket.

    NOTICE:
    1. Be sure to remove the all traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear combination light body gasket to prevent water ingress.


2. REMOVE REAR TURN SIGNAL LIGHT BULB

  1. E120536
    Turn the rear turn signal light bulb and the rear light socket and wire in the direction indicated by the arrow and disconnect them as a unit.

  1. Remove the rear turn signal light bulb from the rear light socket and wire.


3. REMOVE REAR LIGHT SOCKET AND WIRE

  1. E120537
    Disconnect the connector and remove the rear light socket and wire.


4. REMOVE REAR COMBINATION LIGHT LENS AND BODY

5. REMOVE REAR COMBINATION LIGHT BODY GASKET

  1. E120576
    Remove the rear combination light body gasket.

    NOTICE:
    1. Be sure to remove the all traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear combination light body gasket to prevent water ingress.


6. REMOVE BACK UP LIGHT BULB

  1. E120577
    Turn the back up light bulb and the rear light socket and wire in the direction indicated by the arrow and remove them as a unit.

  1. Remove the back up light bulb from the rear light socket and wire.


7. REMOVE REAR LIGHT BULB

  1. E120578
    Turn the rear light bulb and the rear light socket and wire in the direction indicated by the arrow and remove them as a unit.

  1. Remove the rear light bulb from the rear light socket and wire.


8. REMOVE REAR LIGHT SOCKET AND WIRE

  1. E120579
    Disconnect the connector.

  1. Remove the rear light socket and wire.


9. REMOVE REAR LIGHT LENS
← REMOVALINSPECTION →