Lexus IS250 · Service Manual SECURITIES

REMOVAL

Removal / installation


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. B125512
    Using a clip remover, remove the 11 clips and cool air intake duct seal.


2. REMOVE FRONT BUMPER ASSEMBLY

  1. B125513E01
    Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedures for the RH side and LH side.

  1. B125605E01
    Put protective tape around the front bumper assembly.

  1. Using a clip remover, remove the 2 clips

  1. Remove the 2 radiator grille protectors.

  1. Remove the bolt and 10 screws.

  1. B125515
    Disengage the 5 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedures for the RH side and LH side.

  1. Disconnect the headlight washer hose. (w/ headlight cleaner system)

  1. Disconnect the connector and remove the front bumper assembly.


3. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

  1. Disconnect the connector.

  1. E123140
    Remove the 3 bolts and the millimeter wave radar sensor assembly.


4. REMOVE LOW PITCHED HORN ASSEMBLY

  1. E114153E01
    Disconnect the connector.

  1. Remove the bolt and the low pitched horn.


5. REMOVE HOOD LOCK CONTROL CABLE COVER

B125182

  1. Remove the 3 screws.

  1. Detach the claw and remove the hood lock control cable cover.


6. REMOVE HOOD LOCK ASSEMBLY

  1. B120731
    Using a screwdriver, remove the hood lock nut cap as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

  1. B127045
    Remove the 2 bolts and nut.

  1. B127046
    Disconnect the hood lock control cable and connector.

  1. Remove the hood lock assembly.

← COMPONENTSINSPECTION →