Lexus IS250 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (Click here)


2. REMOVE FRONT DOOR SCUFF PLATE RH (w/o Illumination)

HINT:
Use the same procedures for the RH side and the LH side.


3. REMOVE FRONT DOOR SCUFF PLATE RH (w/ Illumination)

4. REMOVE FRONT DOOR OPENING TRIM COVER RH

  1. B123353
    Disengage the 6 claws and remove the front door opening trim cover RH.


5. REMOVE SIDE INSTRUMENT PANEL RH

  1. B123354
    Using a moulding remover, disengage the 5 claws and 3 clips, and then remove the side instrument panel RH.


6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

  1. B123355
    Using a moulding remover, disengage the 4 clips and remove the No. 2 instrument panel under cover sub-assembly.


7. REMOVE PASSENGER SIDE KNEE AIRBAG ASSEMBLY

  1. C122442
    Remove the 3 bolts and front passenger side knee airbag assembly.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


8. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

  1. B123356
    Remove the 5 screws <E>.

  1. Disengage the 2 claws.

  1. Disconnect the connectors and remove the glove compartment door assembly.


9. REMOVE GLOVE BOX LIGHT ASSEMBLY

  1. E123581
    Remove the glove box light assembly.

← COMPONENTSINSPECTION →