DTC    P0116    Engine Coolant Temperature Circuit Range / Performance Problem

для подготовки Нажмите здесь


DESCRIPTION

Refer to DTC P0115 (see page Нажмите здесь).

DTC No.
DTC Detection Condition
Trouble Area
P0116
Engine Coolant Temperature (ECT) between -40°C and 60°C (-40°F and 140°F) when engine started, and conditions (a) and (b) met (2 trip detection logic):
(a) Vehicle driven at varying speeds (accelerated and decelerated)
(b) ECT remains within 3°C (5.4°F) of initial ECT
  1. Thermostat
  2. ECT sensor

MONITOR DESCRIPTION

The ECT sensor is used to monitor the ECT. The ECT sensor has a built-in thermistor with a resistance that varies according to the temperature of the engine coolant. When the ECT is low, the resistance of the thermistor increases. When the temperature is high, the resistance drops. These variations in the resistance are reflected in the output voltage from the ECT sensor.
The ECM monitors the sensor voltage and uses this value to calculate the ECT. If the sensor output voltage deviates from the normal operating range, the ECM interprets this deviation as a malfunction in the ECT sensor and sets the DTC.
Examples:
Upon starting the engine, the ECT is between -40°C and 60°C (-40°F and 140°F). If after driving for 250 seconds, the ECT remains within 3°C (5.4°F) of the starting temperature, the DTC is set (2 trip detection logic).

INSPECTION PROCEDURE

УКАЗАНИЕ:
  1. If any of DTCs P0115, P0117 or P0118 are set simultaneously with DTC P0116, the ECT sensor may have an open or a short circuit. Troubleshoot those DTCs first.
  1. Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0116)

  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the tester ON.

  1. Enter the following menus: Powertrain / Engine / DTC.

  1. Read the DTC.


Result:

Display (DTC output)
Proceed to
P0116
A
P0116 and other DTCs
B



B
GO TO DTC CHART (Нажмите здесь)
A


2.INSPECT THERMOSTAT

  1. Remove the thermostat (see page Нажмите здесь).

  1. Check the valve opening temperature of the thermostat.

    Standard:
    80 to 84°C (176 to 183°F)

    УКАЗАНИЕ:
    In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.

  1. Reinstall the thermostat (see page Нажмите здесь).



NG
REPLACE THERMOSTAT (Нажмите здесь)
OK

REPLACE ENGINE COOLANT TEMPERATURE SENSOR (Нажмите здесь)