АДСОРБЕР > УСТАНОВКА

для подготовки Нажмите здесь



1. INSTALL CHARCOAL CANISTER SUPPORT BRACKET


C149115

  1. Install the canister support bracket with the 4 nuts.

    Момент затяжки: 
    5.4 Н*м{ 55 кгс*см , 48 фунт-сила-дюймов }



2. INSTALL CANISTER


    C149111E01

  1. Install the canister with the 4 bolts and 2 plastic nuts.

    Момент затяжки: 
    21 Н*м{ 214 кгс*см , 15 фунт-сила-футов }

  1. Connect the fuel hose to the pipe.



    A150272E01

  1. Connect the air inlet line tube and vent line tube to the pipe, as shown in the illustration. Then push up the retainer to lock the claws, as shown in the illustration.

    ПРИМЕЧАНИЕ:

    1. A150271E01
    2. Check that there are no scratches or foreign objects around the connected part of the fuel tube connector and pipe before performing this work.
    3. After connecting the fuel tank vent tube, check that the fuel tank vent tube is securely connected by pulling the fuel tube connector and pipe.



3. INSTALL FLOOR NO. 1 UNDER COVER


A148659

  1. Install the under cover with the 5 nuts and 5 clips.

  1. Install the 2 hole plugs.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. INSTALL COWL TOP VENTILATOR LOUVER RH


E139771

  1. Install the 6 clips and cowl top ventilator louver RH.

    ПРИМЕЧАНИЕ:
    If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.



6. PERFORM INITIALIZATION

  1. Perform initialization (see page Нажмите здесь).

    ПРИМЕЧАНИЕ:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.