АДСОРБЕР > СНЯТИЕ

для подготовки Нажмите здесь



1. REMOVE COWL TOP VENTILATOR LOUVER RH


E139771

  1. Remove the 6 clips and cowl top ventilator louver RH.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРЕДОСТЕРЕЖЕНИЕ:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE FLOOR NO. 1 UNDER COVER

  1. Remove the 2 hole plugs.



    A148659

  1. Remove the 5 nuts, 5 clips and under cover.



4. REMOVE CANISTER


    C149112E01

  1. Disconnect the fuel tube.

    1. Pinch the retainer and then raise it.

      ПРИМЕЧАНИЕ:
      A150271E01
      1. Do not use any tools in this procedure.
      2. Check for any dirt and foreign matter contamination in the valve and around the connector. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the valve and connector.
      3. Do not allow any scratches or foreign objects on the parts when disconnecting the tube.
      4. Do not forcibly bend, twist or turn the nylon tube.
      5. Protect the disconnected part by covering it with a plastic bag after disconnecting the tube.
      6. If the tube connector and pipe are stuck, push and pull to release them.

  1. Disconnect the 2 canister hoses.



    C149111E01

  1. Remove the 4 bolts, 2 plastic nuts and canister.

  1. Disconnect the purge line hose from the canister.



5. REMOVE CHARCOAL CANISTER SUPPORT BRACKET


C149115

  1. Remove the 4 nuts and canister support bracket.