ТОПЛИВНЫЙ НАСОС > УСТАНОВКА

для подготовки Нажмите здесь

1. Apply a light coat of gasoline to a new gasket, and install it to the fuel tank.
   

2. Connect the fuel hose, and set the fuel suction with pump and gauge.
   

   ПРИМЕЧАНИЕ:

   1. Be careful not to bend the arm of the fuel sender gauge.
      
   2. When connecting the fuel hose, do not forcibly pull the hose.
      

3. Install the set plate with the 8 bolts.
   

   Момент затяжки: 

   6.0 Н*м{ 61 кгс*см , 53 фунт-сила-дюймов }

   УКАЗАНИЕ:

   Align the protrusion of the set plate with the cutout of the fuel suction pump and gauge.

4. Install the fuel main tube and fuel return tube with the 2 tube joint clips.
   

   ПРИМЕЧАНИЕ:

   
   
   1. 
      
   2. Check that there are no scratches or foreign objects on the connecting parts.
      
   3. Check that the fuel tube joint is inserted securely.
      
   4. Check that the tube joint clips are on the collars of the fuel tube joints.
      
   5. After installing the tube joint clips, check that the fuel tube joints have not been pulled off.
      

5. Connect the connector to the fuel suction with pump and gauge tube assembly.
   

1. Install the 6 clips and cowl top ventilator louver RH.
   

   ПРИМЕЧАНИЕ:

   If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.

1. Perform initialization (see page Нажмите здесь).
   

   ПРИМЕЧАНИЕ:

   Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

1. Connect the intelligent tester to the DLC3.
   

2. Turn the engine switch on (IG).
   

   ПРИМЕЧАНИЕ:

   Do not start the engine.

3. Push the intelligent tester main switch ON.
   

4. Select the following menus: Powertrain / Engine / Active Test / Control the Fuel Pump /Speed.
   

5. Check the fuel pump operation.
   
   

   1. Check for pressure in the fuel inlet tube from the fuel line. Check that the sound of fuel flowing in the fuel tank can be heard.
      If no sound can be heard, check the integration relay, fuel pump, ECM and wiring connector.
      

6. Check for fuel leaks.
   
   

   1. Check that there are no fuel leaks anywhere on the system after performing maintenance.
      If there is a fuel leak, repair or replace parts as necessary.
      

1. Install the service hole cover with new butyl tape.
   

1. Remove the rear seat assembly LH (see page Нажмите здесь).