ТОПЛИВНЫЙ НАСОС > СНЯТИЕ

для подготовки Нажмите здесь

ПРЕДОСТЕРЕЖЕНИЕ:

1. Do not smoke or be near an open flame when working on the fuel system.
   
2. Keep gasoline away from rubber or leather parts.
   
3. Do not allow fuel to spray when removing the pipe between the high pressure side fuel pump and the fuel injector. The fuel in the pipe is highly pressurized.
   

1. Discharge fuel system pressure (see page Нажмите здесь).
   

1. Remove the 6 clips and cowl top ventilator louver RH.
   

ПРЕДОСТЕРЕЖЕНИЕ:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

1. Remove the rear seat assembly LH (see page Нажмите здесь).
   

1. Remove the rear seat assembly LH (see page Нажмите здесь).
   

1. Remove the rear seat cushion assembly (see page Нажмите здесь).
   

1. Remove the service hole cover and disconnect the connector from the fuel suction with pump and gauge tube assembly.
   

1. Disconnect the fuel main tube and fuel return tube.
   
   

   1. Remove the 2 tube joint clips and 2 fuel tubes.
      

      ПРИМЕЧАНИЕ:

      1. Remove any dirt and foreign matter on the fuel tube joint before performing this work.
         
      2. Do not allow any scratches or foreign matter on the parts when disconnecting them, as the fuel tube joint contains the O-rings that seal the plug.
         
      3. Perform this work by hand. Do not use any tools.
         
      4. Do not forcibly bend, twist or turn the nylon tube.
         
      5. Protect the disconnected part by covering it with a plastic bag and tape after disconnecting the fuel tubes.
         

2. Remove the 8 bolts and set plate.
   

3. Disconnect the fuel hose.
   

4. Remove the fuel suction with pump and gauge tube from the fuel tank.
   

   ПРИМЕЧАНИЕ:

   1. Make sure that the sender gauge arm does not bend.
      
   2. Do not damage the fuel suction with pump and gauge tube.
      

5. Remove the gasket.