ТОПЛИВНЫЙ НАСОС > РАЗБОРКА

для подготовки Нажмите здесь



1. REMOVE FUEL SENDER GAUGE ASSEMBLY


A149241E01

  1. Disconnect the fuel sender gauge connector from the fuel suction plate.

  1. Press down on the sender gauge claw labeled A. Then slide the sender gauge upward.

    ПРИМЕЧАНИЕ:
    Do not touch the sender plate's resistance plate area or the contact area.



2. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY


A150204

  1. Disconnect the fuel pump connector from the fuel suction plate.



    A149242E01

  1. Using needle nose pliers, remove the E-ring.

  1. Remove the fuel suction plate and spring from the sub-tank.



3. REMOVE FUEL FILTER


    A149243

  1. Disengage the 2 claws and remove the filter from the sub-tank.



4. REMOVE JET PUMP


A156983E01

  1. Using a screwdriver with the tip taped, remove the jet pump from the sub-tank.



    A110138E01

  1. Remove the O-ring from the jet pump.



5. REMOVE FUEL PUMP ASSEMBLY


A150205

  1. Disconnect the fuel pump connector from the fuel pump.



    A150044E01

  1. Disengage the 5 claws on the filter and remove the fuel pump from the fuel filter.

  1. Remove the fuel main valve from the fuel filter.

  1. Remove the 2 O-rings from the fuel main valve.

  1. Remove the O-ring from the fuel filter.

  1. Detach the 2 claws of the fuel filter and remove the cap.

  1. Remove the fuel pressure regulator from the fuel filter.

  1. Remove the 2 O-rings from the pressure regulator.



6. REMOVE BRACKET


A149246E01

  1. Using a screwdriver with the tip taped, disengage the claw and remove the bracket.