ТОПЛИВНЫЙ НАСОС > ПОВТОРНАЯ СБОРКА

для подготовки Нажмите здесь

1. Install the bracket to the fuel filter.
   

1. Apply gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.
   

2. Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel main valve and fuel pressure regulator.
   

3. Install the fuel main valve and fuel pressure regulator to the fuel filter.
   

4. Attach the 2 claws of the fuel filter and install the cap.
   

   ПРИМЕЧАНИЕ:

   1. Make sure that the fuel main valve and fuel pressure regulator is not installed backwards. If installed backwards, the engine may stall.
      
   2. Make sure the O-rings are not cut or pinched during the installation.
      
   3. Attach the claws securely.
      

5. Engage the 5 claws on the fuel filter and install the fuel pump with pump filter.
   

   ПРИМЕЧАНИЕ:

   1. Make sure the O-rings are not cut or pinched during the installation.
      
   2. Attach the claws securely.
      

6. Connect the fuel pump connector to the fuel pump.
   

1. Apply gasoline to a new O-ring and install it to the jet pump.
   

2. Install the jet pump to the sub-tank as shown in the illustration.
   

1. Install the fuel filter to the sub-tank and attach the 2 claws.
   

1. Install the spring to the fuel suction plate shaft.
   

2. Install the fuel suction plate to the sub-tank.
   

3. Install a new E-ring.
   

4. Connect the fuel pump connector to the fuel suction plate.
   

1. Set the fuel sender gauge to the fuel sub-tank. Then slide the sender gauge downward to install it.
   

2. Connect the fuel sender gauge connector to the fuel suction plate.
   

   ПРИМЕЧАНИЕ:

   Do not touch the sender plate's resistance plate area or the contact area.