РЕЗИСТОР ТОПЛИВНОГО НАСОСА > УСТАНОВКА

для подготовки Нажмите здесь



1. INSTALL FUEL PUMP RESISTOR


A148913

  1. Install the resistor with the bolt.

    Момент затяжки: 
    5.0 Н*м{ 51 кгс*см , 44 фунт-сила-дюймов }

  1. Connect the connector to the resistor.



2. INSTALL ENGINE ROOM SIDE COVER LH


    A149481

  1. Install the side cover with the 4 clips.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. INSTALL COWL TOP VENTILATOR LOUVER RH


E139771

  1. Install the 6 clips and cowl top ventilator louver RH.

    ПРИМЕЧАНИЕ:
    If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.



5. PERFORM INITIALIZATION

  1. Perform initialization (see page Нажмите здесь).

    ПРИМЕЧАНИЕ:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.