СИСТЕМА ПОСАДКИ И ЗАПУСКА > ПРОЦЕДУРА ПОИСКА НЕИСПРАВНОСТЕЙ

для подготовки Нажмите здесь


УКАЗАНИЕ:
  1. Use these procedures to troubleshoot the entry and start system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

    1. Using the intelligent tester, check if the CAN communication system is functioning normally (see page Нажмите здесь).
      Result 
      Result
      		Proceed to
      DTC is not output
      		A
      DTC is output
      		B



    		B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART
    A


    4.CHECK FOR DTC*

    1. Check for DTCs and note any stored DTCs (see page Нажмите здесь).

    2. Delete the DTCs.

    3. Check whether the same DTC(s) relevant to the SFI system or entry and start system recurs by reproducing the symptoms indicated by the noted DTC(s) in the first step above.
      Result 
      Result
      		Proceed to
      DTC output does not reoccur
      		A
      SFI system DTC output reoccurs
      		B
      Entry and start system DTC output reoccurs
      		C



    		B.
    GO TO SFI SYSTEM

    		C.
    GO TO STEP 7
    A


    5.ТАБЛИЦА ПРИЗНАКОВ НЕИСПРАВНОСТЕЙ
      Result 
      Result
      		Proceed to
      Fault is not listed in problem symptoms table
      		A
      Fault is listed in problem symptoms table
      		B


    		B.
    GO TO STEP 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*

    1. Terminals of ECU (see page Нажмите здесь)

    2. Data List / Active Test (see page Нажмите здесь)


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END