ВЫКЛЮЧАТЕЛЬ ЗАЖИГАНИЯ > ПРОВЕРКА

для подготовки Нажмите здесь



1. INSPECT ENGINE SWITCH


  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		Switch Position
    		Specified Condition
    7 (SS1) - 5 (GND)
    		Not pushed
    		10 kΩ or higher
    2 (SS2) - 5 (GND)
    		Not pushed
    		10 kΩ or higher
    7 (SS1) - 5 (GND)
    		Pushed
    		Below 1 Ω
    2 (SS2) - 5 (GND)
    		Pushed
    		Below 1 Ω



    B106647E13

    If the result is not as specified, replace the engine switch.



  1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

    УКАЗАНИЕ:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
    1. If the voltage is too low, the indicator will not illuminate.

    OK:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    		Illuminates
    Battery positive (+) → Terminal 12 (INDS)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    		Illuminates
    Battery positive (+) → Terminal 13 (INDW)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    		Illuminates



    A109252E22

    If the result is not as specified, replace the engine switch.