ВЫПУСКНАЯ ТРУБА > СНЯТИЕ

для подготовки Нажмите здесь


ПРЕДОСТЕРЕЖЕНИЕ:
  1. The procedures should be performed by at least 2 people.
  2. Wear protective gloves when removing the exhaust pipe.
  3. The exhaust pipe is extremely hot immediately after the engine has stopped.
  4. Confirm that the exhaust pipe has cooled down before removing it.



1. REMOVE COWL TOP VENTILATOR LOUVER RH


E139771

  1. Remove the 6 clips and cowl top ventilator louver RH.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРЕДОСТЕРЕЖЕНИЕ:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR


4. REMOVE NO. 1 DIFFERENTIAL SUPPORT PROTECTOR


5. REMOVE NO. 6 ROCKER PANEL MOULDING PROTECTOR

  1. Remove the 2 clips, screw and protector.



6. REMOVE NO. 5 ROCKER PANEL MOULDING PROTECTOR

  1. Remove the 2 clips, screw and protector.



7. REMOVE REAR FLOOR SIDE MEMBER COVER LH


    A132842

  1. Remove the clip, nut, 5 screws and cover.



8. REMOVE REAR FLOOR SIDE MEMBER COVER RH

  1. Remove the clip, nut, 5 screws and cover.



9. REMOVE FRONT FLOOR COVER LH


    A148605E01

  1. Remove the 3 clips, 2 screws, 4 grommets and cover.



10. REMOVE FRONT FLOOR COVER RH

  1. Remove the 3 clips, 2 screws, 4 grommets and cover.



11. REMOVE FRONT FLOOR CENTER BRACE


    A147271

  1. Remove the 4 bolts and brace.



12. DISCONNECT HEATED OXYGEN SENSOR (for Sensor 2)

  1. Disconnect the 2 grommets from the floor panel.



  1. Using SST, loosen the 2 sensors, and then disconnect the sensor by hand.

    Специальный инструмент (SST):
    09224-00010  

    ПРИМЕЧАНИЕ:
    Do not strike the metal part of the sensor.



    A147210E02



13. REMOVE FRONT EXHAUST PIPE ASSEMBLY

  1. Temporarily loosen the 8 bolts on the tailpipe and manifold sides.

  1. Remove the 4 nuts and 4 bolts from the exhaust manifold LH and RH side.

  1. Remove the 4 bolts from the tailpipe LH and RH side. Then remove the front exhaust pipe.

  1. Remove the 2 gaskets from the exhaust manifold side and the 2 gaskets from the tailpipe side.



14. REMOVE TAILPIPE LH

  1. Disconnect the 3 exhaust pipe supports to remove the tailpipe.



15. REMOVE TAILPIPE RH


  1. Disconnect the 3 exhaust pipe supports to remove the tailpipe.


    A147005



16. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY


    A132844

  1. Remove the 2 bolts and bracket.