ЭБУ ВЕНТИЛЯТОРА СИСТЕМЫ ОХЛАЖДЕНИЯ > УСТАНОВКА

для подготовки Нажмите здесь



1. INSTALL COOLING FAN ECU


    A132852

  1. Install the ECU with the 2 screws.

    Момент затяжки: 
    2.5 Н*м{ 25 кгс*см , 22 фунт-сила-дюймов }

  1. Connect the 3 connectors.



2. INSTALL NO. 1 AIR CLEANER INLET


A158334E01

  1. Align the holes with the connection areas labeled A, and attach the No. 1 air cleaner inlet.



    A148822

  1. Install the No. 1 air cleaner inlet with the 2 bolts.

    Момент затяжки: 
    5.0 Н*м{ 51 кгс*см , 44 фунт-сила-дюймов }



3. INSTALL AIR CLEANER INLET COVER


A148821E01

  1. Attach the 4 clips B.

    ПРИМЕЧАНИЕ:
    1. Make sure the clips are attached securely.
    2. Attaching the clips forcefully or hitting the top of the clips may damage them.

  1. Install the air cleaner inlet cover with the 5 clips A.



4. INSTALL V-BANK COVER SUB-ASSEMBLY


A148820E01

  1. After sliding the cover from the vehicle front to the rear to attaching the 2 clips A, attach the 4 clips B and install the V bank cover.

    ПРИМЕЧАНИЕ:
    1. Make sure the clips are attached securely.
    2. Attaching the clips forcefully or hitting the top of the clips may damage them.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. INSTALL COWL TOP VENTILATOR LOUVER RH


E139771

  1. Install the 6 clips and cowl top ventilator louver RH.

    ПРИМЕЧАНИЕ:
    If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.



7. PERFORM INITIALIZATION

  1. Perform initialization (see page Нажмите здесь).

    ПРИМЕЧАНИЕ:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.