СТАРТЕР (для 1,6 кВт) > РАЗБОРКА

для подготовки Нажмите здесь



1. REMOVE REPAIR SERVICE STARTER KIT


    A145255

  1. Remove the nut, and disconnect the lead wire from terminal C.



    A145256

  1. Remove the 2 screws and repair service starter kit from the starter drive housing.

  1. Remove the return spring and the plunger from the repair service starter kit.



2. REMOVE STARTER YOKE ASSEMBLY


    A145257

  1. Remove the 2 bolts, and pull out the starter yoke assembly together with the starter commutator end frame assembly from the starter drive housing assembly.



    A145258

  1. Remove the starter yoke from the starter commutator end frame.



3. REMOVE STARTER ARMATURE PLATE


    A145259

  1. Remove the starter armature plate from the starter yoke.



4. REMOVE STARTER COMMUTATOR END FRAME COVER


    A145260

  1. Using a screwdriver, remove the starter commutator end frame cover from the starter commutator end frame.



5. REMOVE STARTER ARMATURE ASSEMBLY


    A145261

  1. Hold the starter commutator end frame in a vise between aluminum plates.

    ПРИМЕЧАНИЕ:
    Do not overtighten the vise.

  1. Using snap ring pliers, remove the snap ring.

  1. Remove the starter armature assembly and plate washers from the commutator end frame.

    ПРИМЕЧАНИЕ:
    Do not drop the starter armature assembly.



6. REMOVE PLANETARY GEAR


    A145262

  1. Remove the 3 planetary gears from the starter drive housing.



7. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

  1. Remove the starter center bearing clutch sub-assembly with the starter drive lever set pin from the starter drive housing.



    A145263

  1. Remove the starter drive lever set pin from the starter center bearing clutch sub-assembly.