ПРИВОДНОЙ РЕМЕНЬ > СНЯТИЕ

для подготовки Нажмите здесь



1. REMOVE V-BANK COVER SUB-ASSEMBLY


A148820E01

  1. While using both hands, lift the rear side of the cover upwards to detach the 4 clips B. Slide the cover towards the front of the vehicle to detach the 2 clips labeled A, and remove the V-bank cover.

    ПРИМЕЧАНИЕ:
    The V-bank cover may be damaged if its front and rear are lifted at the same time.



2. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY


A148821E01

  1. Remove the 5 clips A.

  1. Lift up the air cleaner inlet cover to detach the 4 clips B, and remove the cover.



3. REMOVE NO. 1 AIR CLEANER INLET


A148822

  1. Remove the 2 bolts.



    A158332E01

  1. Hold the air cleaner inlet by the protrusions A and B, and detach the connections.

  1. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion C.

  1. Hold the air cleaner inlet by the protrusions D and E, and detach the connections.

  1. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion F.



4. REMOVE INTAKE AIR CONNECTOR PIPE


A148823

  1. Disconnect the No. 1 ventilation hose and No. 2 ventilation hose from the intake air connector pipe.

  1. Loosen the 3 hose clamps, and remove the intake air connector pipe.



5. REMOVE V-RIBBED BELT


    A149056

  1. Rotate the tensioner pulley counterclockwise to loosen the belt tension.

    УКАЗАНИЕ:
    The pulley bolt for the belt tensioner has a left-handed thread.




      A150822E01

    1. While turning the belt tensioner counterclockwise, align the holes. Insert a bar of φ5 mm (0.20 in.) into the holes to fix the belt tensioner in place.

  1. Remove the V belt.