РАСПРЕДВАЛ (для ряда 2) > УСТАНОВКА

для подготовки Нажмите здесь

1. Apply a light coat of engine oil to the camshaft journals, camshaft housings and bearing caps.
   

2. Install the No. 1 and No. 2 camshaft to the camshaft housing.
   

3. Confirm the marks and numbers on the camshaft bearing caps and place them each in their proper positions and directions.
   

4. Temporarily install the 8 bolts in the order shown in the illustration.
   

1. Make sure that the valve rocker arms are installed as shown in the illustration.
   

2. Apply seal packing in a continuous line as shown in the illustration.
   

   Seal packing:

   Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
   

   Standard seal diameter:

   3.5 to 4.0 mm (0.138 to 0.158 in.)
   

   ПРИМЕЧАНИЕ:

   1. Remove any oil from the contact surface.
      
   2. Install the camshaft housing within 3 minutes and tighten the bolts within 15 minutes after applying seal packing.
      
   3. Do not start the engine for at least 2 hours after the installation.
      

3. Install the camshaft housing, and install the 12 bolts in the order shown in the illustration.
   

   Момент затяжки: 

   10 Н*м{ 102 кгс*см , 7 фунт-сила-футов } for Bolt A

   30 Н*м{ 306 кгс*см , 22 фунт-сила-футов } for Except bolt

   ПРИМЕЧАНИЕ:

   Make sure that the knock pin of the camshaft is positioned as shown in the illustration before installing the camshaft housing.

4. Tighten the 8 bolts in the order shown in the illustration.
   

   Момент затяжки: 

   16 Н*м{ 163 кгс*см , 12 фунт-сила-футов }

   ПРИМЕЧАНИЕ:

   Thoroughly wipe clean any seal packing.

1. Install the timing chain (see page Нажмите здесь).