РАСПРЕДВАЛ (для ряда 2) > СНЯТИЕ

для подготовки Нажмите здесь



1. DISCHARGE FUEL SYSTEM PRESSURE

  1. Discharge fuel system pressure (see page Нажмите здесь).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРЕДОСТЕРЕЖЕНИЕ:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE CHAIN SUB-ASSEMBLY

  1. Remove the timing chain (see page Нажмите здесь).



4. REMOVE CAMSHAFT BEARING CAP (for Bank 2)


    A149467E01

  1. Make sure that the knock pin of the camshaft is positioned as shown in the illustration.



    A148230E01

  1. Uniformly loosen and remove the 8 bearing cap bolts in the sequence shown in the illustration.



    A148231E01

  1. Uniformly loosen and remove the 18 bearing cap bolts in the sequence shown in the illustration.

    ПРИМЕЧАНИЕ:
    Uniformly loosen the bolts while keeping the camshaft level.

  1. Remove the 7 bearing caps.

    ПРИМЕЧАНИЕ:
    Arrange the removed parts in the correct order.

  1. Remove the No. 1 and No. 2 camshafts.



5. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY (for Bank 2)


    A148234

  1. Remove the camshaft housing by prying between the cylinder head and camshaft housing with a screwdriver.

    ПРИМЕЧАНИЕ:
    Be careful not to damage the contact surfaces of the cylinder head and camshaft housing.

    УКАЗАНИЕ:
    Tape the screwdriver tip before use.