СТАРТЕР (для 1,6 кВт) > СНЯТИЕ

для подготовки Нажмите здесь



1. REMOVE COWL TOP VENTILATOR LOUVER RH


E139771

  1. Remove the 6 clips and cowl top ventilator louver RH.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРЕДОСТЕРЕЖЕНИЕ:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE GENERATOR ASSEMBLY

  1. Remove the generator (see page Нажмите здесь).



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY

  1. Remove the front exhaust pipe (see page Нажмите здесь).



5. REMOVE ENGINE UNDER COVER REAR LH


    C150797

  1. Выверните 2 винта и снимите левую заднюю защиту картера двигателя.



6. REMOVE ENGINE UNDER COVER REAR RH

УКАЗАНИЕ:
Детали с правой стороны снимаются в той же последовательности, что и с левой стороны.



7. DISCONNECT FRONT STABILIZE BAR


C148487

  1. Выверните 4 болта и отсоедините штангу стабилизатора от задней скобы.



8. REMOVE ENGINE UNDER COVER RH


    A149377

  1. Remove the screw, clip and engine under cover RH.



9. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    A146962

  1. Remove the 4 bolts and front suspension member reinforcement.



10. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE


    A149095

  1. Remove the dipstick.

  1. Remove the 2 bolts and dipstick guide.



11. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A145303

  1. Disconnect the sensor connector.



    A145304

  1. Remove the 3 bolts and heat insulator.



12. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH


    A145305

  1. Remove the 8 nuts, exhaust manifold and gasket.



13. REMOVE NO. 3 EXHAUST MANIFOLD HEAT INSULATOR


    A149809

  1. Remove the 3 bolts and No. 3 exhaust manifold heat insulator.



14. REMOVE STARTER ASSEMBLY


    A146974

  1. Detach the 11 claws and remove the starter terminal upper cover.



    A146976

  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the wire harness.



    A146381

  1. Remove the 2 bolts and starter.



    A146978

  1. Remove the nut and starter terminal lower cover.



    A157589

  1. Remove the flywheel housing side cover.