ГИДРАВЛИЧЕСКИЙ КЛАПАН ИЗМЕНЕНИЯ ФАЗ > ПРОВЕРКА

для подготовки Нажмите здесь



1. INSPECT CAMSHAFT TIMING OIL CONTROL ASSEMBLY

  1. Measure the resistance between the terminals.

    Standard resistance:
    6.9 to 7.9 Ω at 20°C (68°F)
    If the result is not as specified, replace the oil control valve.



    A152200E01

  1. Connect the battery's positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the valve.

    OK:
    Condition
    		Specified Condition
    Battery positive (+) voltage is applied
    		Valve moves in left arrow direction shown in illustration
    Battery positive (+) voltage is cut off
    		Valve moves in right arrow direction shown in illustration

    If the result is not as specified, replace the oil control valve.

    ПРИМЕЧАНИЕ:
    Do not allow foreign matter to contact the oil seal face of the oil control valve (connecting surface with cylinder head cover sub-assembly).

    УКАЗАНИЕ:
    If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be output.