ГИДРАВЛИЧЕСКИЙ КЛАПАН ИЗМЕНЕНИЯ ФАЗ > СНЯТИЕ

для подготовки Нажмите здесь



1. REMOVE COWL TOP VENTILATOR LOUVER RH


E139771

  1. Remove the 6 clips and cowl top ventilator louver RH.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРЕДОСТЕРЕЖЕНИЕ:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE V-BANK COVER SUB-ASSEMBLY


A148820E01

  1. While using both hands, lift the rear side of the cover upwards to detach the 4 clips B. Slide the cover towards the front of the vehicle to detach the 2 clips labeled A, and remove the V-bank cover.

    ПРИМЕЧАНИЕ:
    The V-bank cover may be damaged if its front and rear are lifted at the same time.



4. REMOVE AIR CLEANER INLET COVER


A148821E01

  1. Remove the 5 clips A.

  1. Lift up the air cleaner inlet cover to detach the 4 clips B, and remove the cover.



5. REMOVE NO. 1 AIR CLEANER INLET


A148822

  1. Remove the 2 bolts.



    A158332E01

  1. Hold the air cleaner inlet by the protrusions A and B, and detach the connections.

  1. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion C.

  1. Hold the air cleaner inlet by the protrusions D and E, and detach the connections.

  1. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion F.



6. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1)


A149393

  1. Disconnect the oil control valve connector.

  1. Remove the bolt and oil control valve.

  1. Remove the O-ring from the oil control valve.



7. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2)


A149392

  1. Disconnect the oil control valve connector.

  1. Remove the bolt and oil control valve.

  1. Remove the O-ring from the oil control valve.