ECM > СНЯТИЕ

для подготовки Нажмите здесь



1. REMOVE COWL TOP VENTILATOR LOUVER RH


E139771

  1. Remove the 6 clips and cowl top ventilator louver RH.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРЕДОСТЕРЕЖЕНИЕ:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE AIR CLEANER INLET COVER


A148821E01

  1. Remove the 5 clips A.

  1. Lift up the air cleaner inlet cover to detach the 4 clips B, and remove the cover.



4. REMOVE ENGINE ROOM SIDE COVER LH


    A149481

  1. Remove the 4 clips and engine room side cover.



5. REMOVE ENGINE ROOM ECU COVER


A149899

ПРИМЕЧАНИЕ:
  1. Wipe off any water on or around the engine room ECU cover.
  2. Perform these procedures in a dry place away from rain, etc.
  3. Do not allow water to enter the ECM through its connectors areas, screw areas, etc.

  1. Remove the 3 bolts and engine room ECU cover.



6. REMOVE TCM


A149900

  1. Disconnect the 4 TCM connectors.

  1. Remove the 2 nuts and TCM.



7. REMOVE ECM


A149901

  1. Disconnect the 6 ECM connectors.

  1. Remove the 2 nuts and ECM.