ДАТЧИК ТЕМПЕРАТУРЫ ОХЛАЖДАЮЩЕЙ ЖИДКОСТИ > ПРОВЕРКА

для подготовки Нажмите здесь



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR



A108624E16

  1. Partially soak the sensor in water and warm up the water.

  1. Measure the resistance between the terminals.

    Standard resistance:
    Condition
    		Specified Condition
    Approx. 20°C (68°F)
    		2.32 k to 2.59 kΩ
    Approx. 80°C (176°F)
    		0.310 k to 0.326 kΩ

    If the result is not as specified, replace the sensor.

    ПРИМЕЧАНИЕ:
    When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry.