КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ > СНЯТИЕ

для подготовки Нажмите здесь



1. REMOVE COWL TOP VENTILATOR LOUVER RH


E139771

  1. Remove the 6 clips and cowl top ventilator louver RH.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРЕДОСТЕРЕЖЕНИЕ:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE V-BANK COVER SUB-ASSEMBLY


A148820E01

  1. While using both hands, lift the rear side of the cover upwards to detach the 4 clips B. Slide the cover towards the front of the vehicle to detach the 2 clips labeled A, and remove the V-bank cover.

    ПРИМЕЧАНИЕ:
    The V-bank cover may be damaged if its front and rear are lifted at the same time.



4. REMOVE AIR CLEANER INLET COVER


A148821E01

  1. Remove the 5 clips A.

  1. Lift up the air cleaner inlet cover to detach the 4 clips B, and remove the cover.



5. REMOVE NO. 1 AIR CLEANER INLET


A148822

  1. Remove the 2 bolts.



    A158332E01

  1. Hold the air cleaner inlet by the protrusions A and B, and detach the connections.

  1. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion C.

  1. Hold the air cleaner inlet by the protrusions D and E, and detach the connections.

  1. Rotate the No. 1 air cleaner inlet as shown in the illustration to detach the protrusion F.



6. REMOVE NO. 1 ENGINE UNDER COVER


    A132845

  1. Remove the 13 screws, 7 clips and cover.



7. DRAIN ENGINE COOLANT

ПРЕДОСТЕРЕЖЕНИЕ:
Do not remove the radiator reservoir cap and vent plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    УКАЗАНИЕ:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A132825E01

  1. Remove the radiator reservoir cap, and using a 6 mm hexagon wrench, remove the vent plug.

  1. Drain coolant.



  1. Loosen the 2 cylinder block drain cock plugs.


    A146955E01



8. REMOVE INTAKE AIR CONNECTOR PIPE


A148823

  1. Disconnect the No. 1 ventilation hose and No. 2 ventilation hose from the intake air connector pipe.

  1. Loosen the 3 hose clamps, and remove the intake air connector pipe.



9. REMOVE THROTTLE BODY


A148824

  1. Disconnect the throttle motor connector.

  1. Remove the 4 bolts and throttle body.



    A148825

  1. Slide the clamps, and disconnect the No. 4 and No. 5 water by-pass hoses from the throttle body.

  1. Remove the gasket from the intake manifold.