ПЕДАЛЬ АКСЕЛЕРАТОРА > УСТАНОВКА

для подготовки Нажмите здесь



1. INSTALL ACCELERATOR PEDAL


A160094

ПРИМЕЧАНИЕ:
  1. Avoid physical shocks to the accelerator pedal.
  2. Do not disassemble the accelerator pedal assembly.

  1. Connect the tip of the accelerator pedal rod to the bracket.

  1. Install the accelerator pedal with the 3 nuts.

    Момент затяжки: 
    5.4 Н*м{ 55 кгс*см , 48 фунт-сила-дюймов }

  1. Connect the accelerator pedal sensor connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


3. INSTALL COWL TOP VENTILATOR LOUVER RH


E139771

  1. Install the 6 clips and cowl top ventilator louver RH.

    ПРИМЕЧАНИЕ:
    If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.



4. PERFORM INITIALIZATION

  1. Perform initialization (see page Нажмите здесь).

    ПРИМЕЧАНИЕ:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.