ПЕДАЛЬ АКСЕЛЕРАТОРА > ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

для подготовки Нажмите здесь



1. INSPECT ACCELERATOR PEDAL

  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Push the intelligent tester main switch ON.

  1. Enter the following menus: Powertrain / Engine / Data List/ Accelerator Position No. 1, Accelerator Position No. 2.

  1. Read the value displayed on the tester.

    Accelerator Position No. 1 standard voltage:
    Condition
    		Specified Condition
    Accelerator pedal is released
    		0.5 to 1.1 V
    Accelerator pedal is depressed
    		2.6 to 4.5 V

    Accelerator Position No. 2 standard voltage:
    Condition
    		Specified Condition
    Accelerator pedal is released
    		1.2 to 2.0 V
    Accelerator pedal is depressed
    		3.4 to 5.0 V

    If the result is not as specified, check the accelerator pedal, wire harness or ECM.