РЕЛЕ EFI > ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

для подготовки Нажмите здесь



1. REMOVE COWL TOP VENTILATOR LOUVER RH


E139771

  1. Remove the 6 clips and cowl top ventilator louver RH.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРЕДОСТЕРЕЖЕНИЕ:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE EFI RELAY

  1. Remove the EFI relay from the engine room No. 2 relay block.



4. INSPECT EFI RELAY (EFI MAIN, EFI MAIN2)


B060778E19

  1. Measure the resistance of the EFI relay.

    Standard resistance:
    Tester Connection
    		Specified Condition
    3 - 5
    		10 kΩ or higher
    3 - 5
    		Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.



5. INSTALL EFI RELAY


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. INSTALL COWL TOP VENTILATOR LOUVER RH


E139771

  1. Install the 6 clips and cowl top ventilator louver RH.

    ПРИМЕЧАНИЕ:
    If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.



8. PERFORM INITIALIZATION

  1. Perform initialization (see page Нажмите здесь).

    ПРИМЕЧАНИЕ:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.