ПРИВОД КЛАПАНА УПРАВЛЕНИЯ ЗАБОРОМ ВОЗДУХА > УСТАНОВКА

для подготовки Нажмите здесь



1. INSTALL INTAKE AIR CONTROL VALVE ACTUATOR


A152294

  1. Temporarily install the actuator rod to the intake air control valve actuator.

  1. Install the intake air control valve actuator to the intake manifold with the 2 bolts.

    Момент затяжки: 
    21 Н*м{ 214 кгс*см , 15 фунт-сила-футов }

  1. Install the actuator rod to the intake air control valve actuator with the nut.

    Момент затяжки: 
    5.4 Н*м{ 55 кгс*см , 48 фунт-сила-дюймов }

    УКАЗАНИЕ:
    When tightening the nut, hold the actuator rod in place so that it does not move.

  1. Connect the intake air control valve connector.



2. INSTALL V-BANK COVER SUB-ASSEMBLY


A148820E01

  1. After sliding the cover from the vehicle front to the rear to attaching the 2 clips A, attach the 4 clips B and install the V bank cover.

    ПРИМЕЧАНИЕ:
    1. Make sure the clips are attached securely.
    2. Attaching the clips forcefully or hitting the top of the clips may damage them.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. INSTALL COWL TOP VENTILATOR LOUVER RH


E139771

  1. Install the 6 clips and cowl top ventilator louver RH.

    ПРИМЕЧАНИЕ:
    If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.



5. PERFORM INITIALIZATION

  1. Perform initialization (see page Нажмите здесь).

    ПРИМЕЧАНИЕ:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.