ПРИВОД КЛАПАНА УПРАВЛЕНИЯ ЗАБОРОМ ВОЗДУХА > СНЯТИЕ

для подготовки Нажмите здесь



1. REMOVE COWL TOP VENTILATOR LOUVER RH


E139771

  1. Remove the 6 clips and cowl top ventilator louver RH.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРЕДОСТЕРЕЖЕНИЕ:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE V-BANK COVER SUB-ASSEMBLY


A148820E01

  1. While using both hands, lift the rear side of the cover upwards to detach the 4 clips B. Slide the cover towards the front of the vehicle to detach the 2 clips labeled A, and remove the V-bank cover.

    ПРИМЕЧАНИЕ:
    The V-bank cover may be damaged if its front and rear are lifted at the same time.



4. REMOVE INTAKE AIR CONTROL VALVE ACTUATOR


A152294

  1. Disconnect the intake air control valve connector.

  1. Remove the nut, and disconnect the actuator rod.

    УКАЗАНИЕ:
    When loosening the nut, hold the actuator rod in place so that it does not move.

  1. Remove the 2 bolts. Then remove the intake air control valve actuator from the intake manifold.